Skip to content


Your cart is empty


These instructions include the use of the following products:

  • Red Iguana 2-In-1 Stamping + Paint Gel
  • Red Iguana Nail Stamper & Scraper
  • Your choice of nail stamp image plate.


  1. Remove the protective film.
  2. Apply Red Iguana Stamping Gel to the design you wish to stamp.
  3. Remove the excess Stamping Gel with Red Iguana scraper using a 45 degree angle.
  4. Roll the Red Iguana Stamper over the selected design being careful not to use too much pressure.
  5. Transfer the design by rolling the Red Iguana Stamper over the nail.
  6. Cure: LED 60 secs / UV 2 mins.
  7. Apply a clear topcoat for a longer lasting result.


Clean Stamping Plate with Isopropyl alcohol or acetone.

Clean Jelly Stamper with Isopropyl alcohol. It is made of high quality silicone that doesn't break down under the influence of light solvents so is not suited for cleaning with acetone.